I believe pre and post facelift are the same, there might be some difference in the wiring connector but it should just be a plug and play swap.
See the link below for an install guide for your car....
Quickest way would be to snip the old belt in half, then run round all the pulleys with the tensioner set roughly in the middle, mark where it...
Yes had this issue on mine. You need to remove the door card as the rod may have unclipped itself from the back of the handle. Should just be a...
Unfortunately the rise of groups on facebook killed the forums.
Probably have more luck on there.
Bulbs are an easy job, driver side can be fiddly due to lack of space though.
From memory they are H7 bulbs, I would recommend Osram...
It all depends on how rusty it is really, they have a tendancy to rust inside the sills and rear arches which isnt noticable until its...
Bit of CAD
Welded in, hole sawed and part dimple die
More holes then paint
Little bit more weight saving
Yeah it fucked my shit right up, old cunts
Got paid out by the other guys insurance. Was a 90 odd year old bloke, had a bleed on the brain and drifted into my lane.
- Tomei Poncams
- XTD Lightweight Flywheel
- SoCal Tri-Y Manifold
- 2.5" LiamSpec Catback
- Walbro 190L/H Fuel Pump
- 3" LiamSpec ally...
Also changed the rear springs for 7kg/mm. And have finally gussetted the cage to the B pillars. Hole saw will be making an appearance tomorrow to...
Did another day at Combe once it was repaired. Real hot day with lengthy sessions, rear brakes were getting hot, so it was time for some cooling....
Slightly raised ally floor
After this I went to anglesey. Trailed on the replacement trailer...
So it has been a while, quite a few changes, pic heavy, not all in order.
Front brake cooling ducts
Bought a trailer, was too...
It is a fairly big job.
Id imagine somewhere around 5-6 hours labour if you are getting a garage to do it.
As for parts, the Almera is...
BC Racing are the only reputable brand that still stock N16 coilovers.
They are quite few and far between nowadays. And the chances of finding a clean one are even more slim.
Keep an eye on eBay and Gumtree, aswell...
Could be worth using a fluke to check continuity between injector earth pin and ground whilst cranking.
I have heard of ECUs refusing to start...
Separate names with a comma.