Search results

It is the wrong sized pulley that caused the problem

Thanks for the suggestion. I wasn't able to do that because the nut clamp for the adjuster of the other belt is all chewed up and won't budge so a new alternator belt cant be fitted yet. I did find that taking the alternator belt adjuster almost to its limit (6mm thread left) I was able to...

Hi I bought a 1110mm 6-rib drive belt for my N16 almera 1.5 2003 model with a/c, in readiness as my alternator was failing. Have fitted the new alternator only to find that the old belt is too long so the new belt would be too . I now find that the pulley on the new alternator has a smaller...

Hi Hate to resurrect an old thread but Almeras do rust: came across this thread when googling because my sump has rusted through! The crossmember on my 2003 N16 had completely rusted through and crumbled in my hands. Not surprised it failed the MOT. It didn't the previous year and no...

Hi I have a RHD 2003 petrol Almera 1.5S which I am told may have a Dongle unit. I need to change the ecu and immobiliser but will need a Dongle unit if it has one. My dealer cant tell me from the chassis + engine number + registration. He has sent me a page from the manual which says Quote...

Hi I have a 2003 Nissan Almera 1.5S RHD. This has the ecu/ecm in the cabin. I have a shorting problem on the ecu/ecm side of the ECM Relay which blows the 10A fuse. The ECM Relay pin 3 feeds the ecm at 110 and 112 but does so through the Joint Connector-6 F114 pin 1, but one of the circuits on...

Pays not to be confident with cars. Made no difference - all the faults are the same Hope someone can help

I am going by my own diagnosis. Am confident that when the replacement set of engine ecu, Entrance control unit, immobiliser and IMMU arrives the car will work again. Apart from the angst for the total price of £60 it will be solved - and I get two keys for the first time. For the record, if...

Hi I may have to replace the complete set of ecu, immobiliser, ignition lock, ignition antenna, keys and central locking unit. Which sets would be the same as mine 2003 1.5S. Will the radio work using the same code?

Still immobilised. The current position is My daughter has a 2003 Nissan Almera 1.5S petrol RHD. It stalled and will not start. It turns over as usual. When the ignition is turned on the immobiliser lamp blinks 6 times and the stays lit. It doesn’t go off after 15 min so no fault in the...

Someone suggested reprogramming my only key I used the following procedure 1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds. 2. Then turn ignition switch to OFF position. Leave key in ignition switch. 3. After 2 seconds, the system will enter programming mode and...

I checked the voltage between the K-line and the ground when the fan cables are disconnected and it was the same, 2.7V not 12V. Please help as we are stranded in the sticks with no autoelectrician who knows anything about Nissans in the area

Help needed desparately!! My daughter has a 2003 Nissan Almera 1.5S petrol RHD. It stalled and will not start. It turns over as usual. When the ignition is turned on the immobiliser lamp blinks 6 times and the stays lit. The radiator cooling fan comes on when the lamp is lit. I cannot read...

I have this now

Hi To save me the hassle of begging the keycode from my local Nissan does anyone have the software to give the key code for a Nats 6 2003 Almera? My SEC label is 3264-1A2E You could PM me if you prefer

I'm told it is a T14

Does anyone know which type of transponder is fitted in an 03 Almera. Before midyear they were T13 Transponder (Texas Crypto ID60) and post midyear T14 Transponder (Philips Crypto II ID46)

Hi That makes sense: Smart Entrance Control Unit = Central Locking Unit Found easily taking lower valance off

I have a pic on a russian website Hope to find it! http://www.club-nissan.ru/forums/showthread.php?t=162869

Now I need the SEC (Small/Smart/Secure Entrance Control) Label to be able to get the key code/pin. Where is the SEC hidden?