Gtir turbo oil water fitting lines/ t piece for Sr20ve + t

Andy Sunny Gti

Andy Sunny Gti

Hi guys/ girls.
Now I have been forced into getting this turbo converion done as I can't move the car.
Reason being a guy offered to buy my whole exhaust system off the sr20ve I had. Since I was going turbo and for £250 I though why not.
So off they came.
imagejpg1_zpsaecb54e5.jpg

imagejpg15_zps9c3811b4.jpg


Now a lot of people say search, I have for years etc.. But lots of different answers.

Can some just post me a link to buy the following, or I can just paypal the cash to someone and they can do it, then post to me.

What I need
Oil, water fitting lines, t piece etc for my conversion.

Just hit a link for me please so I can buy them now. Need to fit them over the weekend, so have to buy them tomorrow.
Seen a few on eBay but not sure on size fitting, -3an oil line fitting?

The turbo is a gtir t28 ball bearing, going onto an sr20ve.
How do I go about fitting these please?
I take it the old lines on the turbo shown will need to come off?

Cheers.
 
Last edited:
It's a gtir turbo rebuilt with 360 thrust bearing?

I read this, so possible don't need a restrictor?

-----------------------------

No, a restrictor is not absolutely needed. I am running a GTi-R journal bearing turbo with a VE oil pump and no restrictor and I have no issues. You're exactly right though that the size of the oil feed line is important*. I have an -3AN turbo oil feed line. Because of that, I don't absolutely need a restrictor. If you're using a -4AN turbo oil feed line then you will (and probably already did) need a restrictor. If you're running a ball bearing turbo the need for a restrictor is more important. See the link at the bottom.

-----------------------------
 
Last edited:
Right I'm gonna put this thread to bed real quick.

Turbo is not ball bearing so use this Oil Feed line Including T-Piece:
http://www.ebay.co.uk/itm/Garrett-T...arts_Vehicles_CarParts_SM&hash=item19f4fa49ef
I take it your return is sorted?

For Water, buy 2 metres of this in 10mm:
http://www.ebay.co.uk/itm/190953170089?_trksid=p2059210.m2749.l2649&ssPageName=STRK:MEBIDX:IT
Run the heater hose from the Throttle Body and attach to turbo using these Water Banjo Bolts:
http://www.ebay.co.uk/itm/Garrett-T...arts_Vehicles_CarParts_SM&hash=item5aebfb776f
 
You must log in or register to reply here.
Back
Top Bottom