N16 pulsar project

Well my new front lip is questionable and I'll probably get mixed opinions, I'm a university student so for less than $20 nzd. I can't complain.
9f9023c4098375f4b3f84450f072deb1.jpg
03723b217c69eadfd126f4b2da7a95d5.jpg
204f93d1382cf267514f77a6c7ab926f.jpg



Sent from my iPhone using Tapatalk
 
I quite like it. Shame the lines don't line up on the end though, a little over zealous with the cutting knife?
 
It needs to be lifted on that side as you can see it looks out of level. So I cut it at a slightly different angle. But yeah it's a bit short haha


Sent from my iPhone using Tapatalk
 
so i want my exhaust to be a little bit louder, ive got an HKS high flow muffler on the end which makes it a little bit louder, but there are 2 stock mufflers just after the cat converter, has anyone removed one or both of these?? what did it sound like, i dont want to go deaf i just want a bit more noise.....
 
I NEED SOME ADVICE.

Ok so I have found this pulsar. It's cheap. Needs a few things done. High kms but it's not an import so it has no rust. What do you guys think. Good project car?????
ba4de414627f27a2a376883584c6998b.jpg



Sent from my iPhone using Tapatalk
 
Welllll I have so good and bad news haha.
You probably won't see me on here much for a while as I have brought a project car. A 1973 Morris 1300. I'm slowly restoring it as I can afford it.
a37f0b37492dc882b1f4815455a38bbb.jpg



Sent from my iPhone using Tapatalk
 
Back
Top Bottom