N16 Debadgeing

Darren198712

Just chillin'
I was wondering on the Almera Phase 2 front and rear debadging. I am wondering if it has any pins on the front because i can see there is only double sided tape holding it down. I know the Phase 1 the Bonet is different the Nissan badge is basicly embedded into the bonnet.

Thanks Darren
 
The front badge does have pins, leaves holes in the bonnet. Rear badge is just stuck on.

Lisa
 
Lis is right mate.

If you open the bonnet and look underneath where the badge is, you will see the pins thro' the bonnet.
 
If you take the front badge off then you will see the holes in the bonnet! I took the front badge off then had to put it back on because of that :(
 
this is the phase 2 though not the phase 1. The phase one has a grove for the nissan Badge the phase 2 does not have a grove for it so i was wondering if it had pins

Edit I am going to ask the nissan dealers first for a spair part first before i take it off
 
Although my car is phase 1 I have a phase 2 bonnet on it! So I have no groove for the badge. Which I thought would make it easier for de-badging but then found the holes in the bonnet. Was quoted £100 to fill in the holes! :eek: Which I didn't think was worth it.
 
Lis said:
Although my car is phase 1 I have a phase 2 bonnet on it! So I have no groove for the badge. Which I thought would make it easier for de-badging but then found the holes in the bonnet. Was quoted £100 to fill in the holes! :eek: Which I didn't think was worth it.

i called up nissan and they said there was no pins in the badge for the bonnet I will double check before i debadge it :) i may be getting my car thuresday or may be saturaday.

edit
I think if the Phase 2 had holes in i think it would be cheaper to debadge a phase 1
 
Trust me mate, there is holes.

I also wanted to do this and have had a look and own a Phase 2 ;)
 
I dont know if phase 1 has holes , can't remember properly but i don't think it does. Phase 2 definately has holes
 
I called up nissan and they said there was no holes on the phase 2 bonnet. I will double checl before i do any thing

Edit. Looks like i am going to debadge the back they are holes on the front :(
 
Back
Top Bottom