Problem with Heater Blower Fan

  • Thread starter Thread starter chip
  • Start date Start date
C

chip

Guest
I have a problem with my sons 1997 2.0 Gti the heater blower does not work on positions 1,2 & 3 but goes on boost on position 4 I have traced the wiring to a circuit board on the heater unit secured by two screws. It just slots into the unit. The board doesn't look too good there's a rust bleb in the centre. there is power to one of the wires in the connection that comes from the switch. I'm thinking this may be the problem.

I intend to renew this circuit board first. just thought someone else may have had similar problem? Any thoughts would be greatful

Thanks
Chip
 
yep. very common problem. had this on my gti. i just soldered across the connections and it works fine now. think the new heater cards are about £35.
 
andrewb said:
yep. very common problem. had this on my gti. i just soldered across the connections and it works fine now. think the new heater cards are about £35.
Thanks
I'll try the soldering bit myself as well
Chip
 
Back
Top Bottom