seat runners

  • Thread starter Thread starter nismo
  • Start date Start date
just got the new car and got a show on sunday so getting that sorted first soon as 1 is done will pm u ok
 
im interested (possibly) stick me donw on the list and i'll see what postion im in later on. would need to know whether they'll fit most seats, as i havent actually got mine yet.
 
hey. put me on too

1 rowdy_gti
2 stewart04
3 alan blue
4 always sideways
5 Hally (possibly)
6 leekawey
 
found a set of runners when i was looking for bits from the old car so will get 1 set made up soon wont take me long when i start
 
ok new list is
1 stewart04
2 alan blue
3 always sideways
4 Hally (possibly)
5leekawey
 
How many inches lower would I be in the car using new seats, I am quite tall, too tall to wear a helmet in my car without going through the roof :) If I can take a few inches from my height then I will deffo get the runners from you.

Edit: Also when you move to a harness where do they attach too?
 
eviljonny said:
How many inches lower would I be in the car using new seats, I am quite tall, too tall to wear a helmet in my car without going through the roof :) If I can take a few inches from my height then I will deffo get the runners from you.

Edit: Also when you move to a harness where do they attach too?
Click to expand...

Depends on the seat and having no runners onviously lowers u in the seat......the harness attaches to the rear seat belt mount, and if your using an after market seat you need one on the frame near the centre console and you can use the ones near the door that the OE belt attaches to.....

The base attachment can be seen here on the frame....
CTR003.jpg


The rear seat belt one and also make out the ones near the doors.....
almeragti004.jpg
 
alan_blue said:
looks a good frame, did you make it yourself?
Click to expand...

Its a nissan maxima one from states all the bolts lined up bar the one in the top right which required some drilling and a piece of tubing as a support and i had to move the seat belt attachment to the other side and get re-welded.....
 
I could be interested in a set of these but just curious will there be somewhere for the normal seat belt buckle to fit too?
 
in the proses the now got alot on but so after donny i will get stuck in to them and make a prototype and see who is defo intrested and there will be a seat belt mount
 
You must log in or register to reply here.
Back
Top Bottom