Yeah pedal power soon haha
My Mera
- Thread starter Freaky_Fish
- Start date
Fresh underseal
can't wait to have it back on the road but so far off it haha.
Nope I bought a spray gun for the compressor. Think the stuff is called tetraseal or something similar
Ah right. I've not had to sort any rust luckily I did brush underseal it a few years back and I didn't do all of it for some reason lol.
Mine was very good on the rusty apart from tiny patch inner rear arch and under the back seat where it meet's the bottom of the arch,which was cut out,welded sharpish been good since.
I also use denso tape in the danger area's then underseal over the top a few time's.
Have a gander inside the sill's too with a torch, under the kick plate's. In this area i plugged the drain holes out the sill's and filled with motorbike chain grease, wait for it to settle and stick then took the plugs out.
Grease is like glue and stick's like shit to a blanket cheap too.
I also use denso tape in the danger area's then underseal over the top a few time's.
Have a gander inside the sill's too with a torch, under the kick plate's. In this area i plugged the drain holes out the sill's and filled with motorbike chain grease, wait for it to settle and stick then took the plugs out.
Grease is like glue and stick's like shit to a blanket cheap too.
Bit done this morning. Got the gearbox back on with the new clutch disc in. Now to replace all four cv boots with new genuine Nissan ones.
Looking good mate glad to see progress and it all got there ok mate! all correct i hope
Thanks Yeah all arrived fine not checked the cv boots out yet as I've been really busy this weekend but im sure all will be ok. Thanks again for sorting them out for me
Yeah all arrived fine not checked the cv boots out yet as I've been really busy this weekend but im sure all will be ok. Thanks again for sorting them out for meDont worry about it any time i can help i will mate
Had a day of snapping bolts just removing the wings then drilled all the snapped bolts out, masked up for finishing the underseal then It's starting raining
Should be having the engine bay painted next week though so it can all start going back together
Just standard ar2 red. Im not a fan of different coloured bays
Think I left this bit too long :/
Did think that but would still want to treat the rust inside the sill
thought you never had any? Grind that back and see what your left with! may need cutting out and welding.
My guess is... it be worse to the rear of the sill and i covered all the little vent's and sprayed mtx chain oil inside the sill's, for hour or so and unblocked the vent's after
Last edited: