Guess I was wrong lol yeah im going to get all of that side cut out and replaced as the paint is bubbling further back
My Mera
- Thread starter Freaky_Fish
- Start date
Yeah I know. Im a bit worried about doing it now haha
Stripped down the long shaft the other day and used works parts cleaner to clean the old cv grease out. Those fucking clips on the end of the shafts just took me an hour to do one lol. So the short shaft is now stripped apart for cleaning out tomorrow.
Last edited:
Na the Nissan ones come with everything you need so there ones that pull over and clamp in place.
yeah but surely you need some tool to zip them tight?
Yeah it's not the most enjoyable job to be doing but it needs to be done. Just hope they last a lot longer than aftermarket parts
Box arrived for me today
Metal bearing carriers fitted
Built. Not quite sure why I've bought another turbo but I guess it's the temptation of working with them all day haha this is a GTX2867 which I'll have a pulsar compressor housing machined to fit
Metal bearing carriers fitted
Built. Not quite sure why I've bought another turbo but I guess it's the temptation of working with them all day haha this is a GTX2867 which I'll have a pulsar compressor housing machined to fit
Subframe collars going on with a gti steering rack and poly bushes
I seem to be spending most of my time looking for the next part as its all over the place in my garage lol
Yeah they all went on
More driveshaft assembly
Only the short inner joint to finish now hopefully the engine will go back in at the weekend
Only the short inner joint to finish now
hopefully the engine will go back in at the weekend
Done
hope I don't have to do these again for a whileYeah we can get the ball bearing cartridges has to be a whole chra though