Sams VZ-R N1

[Sam]

getting more higher.

16ve

N1

thankyou and good night.

 

[Hally]

good good.

 

[n15...]

Yep they are correct for an n1... share the same factory plug as a dc2 integra type R. Look like they have good life left in them too

 

[Sam]

And the S2K.

 

[Sam]

Eugh



Quick polish

 

[edk]

Was that crap left over from the welding then? Looks lovely now.

 

[Sam]

yeah, heat from the welding, comes right owf

 

[Sam]

Needed to put a stereo in the car due to an imminent camping trip so.

Although ISO leads have an earth present on them the car loom doesn't have the appropriate pin, it relys on earthing through the body of the stereo.

Here's what I did.





Simply bolt it to the earth on the side of the dash cage.

I haz music. Again.

 

[tommo]

Or cheat, they're only £6 on amazon

 

[Simcard]

Do you not have the correct holder for the stereo which earths it? Or are imports different?

 

[Hally]

They're different, stock stereo earths itself but any aftermarket one doesn't.. I've earthed it to a tab lower down behind the plastic next to the dead pedal

-phone-

 

[chunky]

Mine grounds through the Aerial, i don't get any interference either which i was a little surprised at

 

[Sam]

More bits




Bit of a fiddle to get them lined up, but a perfect fit.

 

[Dyldo]

More bits

View attachment 10042
View attachment 10043

Bit of a fiddle to get them lined up, but a perfect fit.

For sale??

Sent from my HP Slate 7 using Tapatalk 4 Beta

 

[Sam]

Not currently, have made things a bit more vibratey, but seemingly only when moving, gear change feels better.

Though I can feel the release bearing beginning to stick a bit now, so that's going to need re-greasing.

 

[Dyldo]

Not currently, have made things a bit more vibratey, but seemingly only when moving, gear change feels better.

Though I can feel the release bearing beginning to stick a bit now, so that's going to need re-greasing.

Sure when the release bearing is getting done, whip them out and get a small group buy going

Sent from my HP Slate 7 using Tapatalk 4 Beta

 

[damienga15de]

Grease is not good on release bearing, makes dust ball up on the shaft and makes it stick worse eventually

Sent from my GT-I9300 using Tapatalk 4 Beta

 

[Sam]

Greased from the factory, so its inevitable really.

 

[Dyldo]

Was it rowdy that recommended graphite powder as an alternative as it remains lubricated as well as the clutch disc dust not sticking to it

Sent from my HP Slate 7 using Tapatalk 4 Beta

 

[rowdy-GTi]

Was it rowdy that recommended graphite powder as an alternative as it remains lubricated as well as the clutch disc dust not sticking to it

Sent from my HP Slate 7 using Tapatalk 4 Beta

Don't think so pal, although it sounds a good idea.
Clean the splines, then a small amount of high temp grease.